Step 1: Prepare Your Fascia Boards
Trim your Trex® fascia boards to achieve clean edges before laying out the fastener placement.
Step 2: Fastener Placement Guidelines
Follow these guidelines for optimal performance with Trex Hideaway Color Match Fascia Screws:
- Place screws 1 inch from board ends.
- Position screws 1 inch from the edge of the rim joist along the edges.
- Align screws vertically in the field of the board, spaced no more than 18 inches apart.
- Use 2 screws for 8-inch fascia (at ends and in the field) or 3 screws for 12-inch fascia (at ends and in the field).
Step 3: Pre-drill Holes for Fascia Fasteners
Use the teal-colored counterbore tool at a 90-degree angle to the board's face. Drill until the counterbore cup stops spinning, then remove any debris from the hole.
Step 4: Install Composite Fascia Plug Screws
Drive the 1-3/4” black epoxy-coated screws using the teal HEXSTIX depth setter tool labeled "Fascia" until you hear the drive change, indicating the screw is set to the designed depth.
Step 5: Installing Fascia Plugs
Center the Trex fascia plug over the hole, aligning the grain with the board's grain. Gently tap the plug flush to the face of the board using a smooth-faced hammer.